Dell S6100, Руководство по настройке

Страница: 353 / 1743

Usage Information
All routers apply the
bgp default local-preference
command setting within the AS. To set the local
preference for a specific route, use the
set local-preference
command in ROUTE-MAP mode.
Related Commands
• set local-preference — assign a local preference value for a specific route.
bgp dmzlink-bw
Enables BGP Link Bandwidth.
Syntax bgp dmzlink-bw
To disable BGP Link Bandwidth, enter the
no bgp dmzlink-bw
command.
Parameters
dmzlink-bw Enter the keyword
dmzlink-bw
to enable BGP Link Bandwidth in BGP multipath.
Defaults N/A
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
9.2(1.0) Introduced on the Z9500.
Usage Information
Configuring or un-configuring the command brings down and brings up the BGP Route Manager, this results in
tear down and re-establishment of all active sessions.
Link Bandwidth has to be configured on the router to tell it to associate Link Bandwidth with prefixes (paths)
and/or to use Link Bandwidth in BGP Multipath route selection.
This is done under BGP configuration and is supported per address family – for IPv4 and IPv6 address families.
The configuration for a particular address family applies across all VRFs configured.
This command must be performed on the router which is attaching link bandwidth to prefixes (typically a border
router) as well as the router which is expected to load share traffic proportional to the bandwidth of the external
links.
Border Gateway Protocol 353