Version
Description
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series.
7.8.1.0
Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.1.1.0
Introduced on the E-Series.
Usage Information
Dell Networking OS supports one ingress and one egress MAC ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed specifications about entries allowed
per ACL, see your line card documentation.
NOTE:
Ingress ACLs are supported on C-Series and S-Series platforms only.
Example
Dell(conf)# mac-access-list access-list standard TestMAC
Dell(config-std-macl)# permit 00:00:00:00:00:00 00:00:00:00:ff:ff count
Dell(config-std-macl)# deny any count
Dell(config-std-macl)#
permit
To forward packets from a specific source MAC address, configure a filter.
Syntax
permit {any |
mac-source-address
[
mac-source-address-mask
]} [count [byte]] |
[log [interval
minutes
] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
•
Use the
no seq
sequence-number
command if you know the filter’s sequence number.
•
Use the
no permit {any |
mac-source-address mac-source-address-mask
}
command.
Parameters
any
Enter the keyword
any
to forward all packets received with a MAC address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified,
a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC
addresses that match).
count
(OPTIONAL) Enter the keyword
count
to count packets processed by the filter.
byte
(OPTIONAL) Enter the keyword
byte
to count bytes processed by the filter.
log
(OPTIONAL) Enter the keyword
log
to include ACL messages in the log.
Access Control Lists (ACL)
245
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...