Dell S6100, Руководство по настройке

Страница: 231 / 1743

Version Description
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series. Increased the name string to accept up to 140 characters.
Prior to version 7.8.1.0, names are up to 16 characters long.
7.4.1.0 Introduced on the E-Series.
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed specification on entries allowed per
ACL, refer to your line card documentation. You can create an IPv6 ACL for control-plane traffic policing for
OSPFv3, in addition to the CoPP support for VRRP, BGP, and ICMP.
permit
To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP.
Syntax permit { ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command syntax if you know the filter’s sequence number
• Use the
no permit { ipv6-protocol-number | icmp | ipv6 | tcp | udp}
command
Parameters
ip-protocol-number Enter an IPv6 protocol number. The range is from 0 to 255.
icmp Enter the keyword icmp to filter internet Control Message Protocol version 6.
ipv6 Enter the keyword
ipv6
to filter any internet Protocol version 6.
tcp Enter the keyword
tcp
to filter the Transmission Control protocol.
udp Enter the keyword
udp
to filter the User Datagram Protocol.
Defaults Not configured.
Command Modes ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
Access Control Lists (ACL) 231