8.4.2.1
Introduced on the S-Series.
8.2.1.0
Introduced on the E-Series TeraScale.
7.8.1.0
Introduced on the C-Series.
7.4.1.0
Introduced on the E-Series TeraScale Added the
monitor
option.
deny icmp
Configure a filter to drop all or specific ICMP messages.
Syntax
deny icmp {
source address mask
| any | host
ipv6-address
} {
destination address
| any | host
ipv6-address
} [
message-type
] [count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
•
Use the
no seq sequence-number
command syntax if you know the filter’s sequence number
•
Use the
no deny icmp {
source address mask
| any | host
ipv6-address
}
{
destination address
| any | host
ipv6-address
}
command
Parameters
source address
Enter the IPv6 address of the network or host from which the packets were sent in the
x:x:x:x::x format followed by the prefix length in the /x format. The range is /0 to /128.
The :: notation specifies successive hexadecimal fields of zero.
mask
Enter a network mask in /prefix format (/x).
any
Enter the keyword
any
to specify that all routes are subject to the filter.
host
ipv6-address
Enter the keyword
host
followed by the IPv6 address of the host in the x:x:x:x::x format.
The :: notation specifies successive hexadecimal fields of zero.
destination address
Enter the IPv6 address of the network or host to which the packets are sent in the
x:x:x:x::x format followed by the prefix length in the /x format. The range is /0 to /128.
The :: notation specifies successive hexadecimal fields of zero.
count
(OPTIONAL) Enter the keyword
count
to count packets processed by the filter.
byte
(OPTIONAL) Enter the keyword
byte
to count bytes processed by the filter.
Defaults
Not configured.
Command Modes
ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.0.2.0
Introduced on the S6000.
8.4.2.1
Introduced on the S-Series.
Access Control Lists (ACL)
225
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...
