Dell S6100, Руководство по настройке

Страница: 1557 / 1743

• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE
then the
stack/slot/port information.
• For a port channel interface, enter the keywords
port-channel
then a number.
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced on the E-Series.
storm-control broadcast (Configuration)
Configure the percentage of broadcast traffic allowed in the network.
Syntax storm-control broadcast [ packets_per_second in]
To disable broadcast rate-limiting, use the
no storm-control broadcast [ packets_per_second in]
command.
storm-control broadcast
[ percentage decimal_value
in | out]
| [wred-profile name]]
[
packets_per_second
in]
To disable broadcast rate-limiting, use the storm-control broadcast [ percentage decimal_value in | out] | [wred-
profile name]] [ packets_per_second in] command.
Storm Control 1557