Version
Description
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.4(0.0)
Introduced on the S-Series and Z9000.
Usage Information
Use this command to bind an SNMP agent to a VRF. The SNMP agent processes the requests from the interfaces
that belong to the specified VRF. If no VRF is specified, then the default VRF is used.
Related Commands
•
— display the information configured on each SNMP user name.
snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
To disable sending link trap messages, use the
no snmp trap link-status
command.
Defaults
Enabled.
Command Modes
INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
Simple Network Management Protocol (SNMP) and Syslog
1517
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...