Dell S6100, Руководство по настройке

Страница: 1264 / 1743

You can apply this command on both physical interfaces and port channels. When you set the service-class
dynamic for a port channel, the physical interfaces assigned to the port channel are automatically configured; you
cannot assign the
service-class dynamic
command to individual interfaces in a port channel.
• All dot1p traffic is mapped to Queue 0 unless you enable the
service-class dynamic dot1p
command
on an interface or globally.
• Layer 2 or Layer 3 service policies supersede dot1p service classes.
Policy-Based QoS Commands
Policy-based traffic classification is handled with class maps. These maps classify data traffic into one of eight classes . Dell Networking OS
enables you to match multiple class maps and specify multiple match criteria. Policy-based QoS is not supported on logical interfaces, such
as port-channels, VLANS, or loopbacks.
bandwidth-percentage
Assign a percentage of weight to the class/queue.
Syntax bandwidth-percentage percentage
To remove the bandwidth percentage, use the
no bandwidth-percentage
command.
Parameters
percentage Enter the percentage assignment of bandwidth to the class/queue. The range is from 1 to
100% (granularity 1%).
Defaults none
Command Modes CONFIGURATION (conf-qos-policy-out)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.1.9.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
1264 Quality of Service (QoS)