Dell S6100, Руководство по настройке

Страница: 1190 / 1743

Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
6.5.3.0 Introduced on the E-Series.
permit
Configure a permit rule. A permit rule excludes the matching packets from PBR classification and routes them using conventional routing.
Syntax permit { ip-protocol-number | protocol-type } { source mask | any | host ip-
address } { destination mask | any | host ip-address } [ bit ] [operators]
To remove the rule, use one of the following:
• If you know the filter sequence number, use the
no seq sequence-number syntax
command.
• You can also use the no permit { ip-protocol-number | protocol-type } { source mask |
any | host ip-address } { destination mask | any | host ip-address } [ bit ]
[operators]
command.
Parameters
ip-protocol-number Enter a number from 0 to 255 for the protocol identified in the IP protocol header.
protocol-type Enter one of the following keywords as the protocol type:
•
icmp
for internet control message protocol
•
ip
for any internet protocol
•
tcp
for transmission control protocol
•
udp
for user datagram protocol
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to the filter.
host ip-address Enter the keyword
host
then he IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
1190 Policy-based Routing (PBR)