Command Modes
ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell
Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced to all platforms.
Usage Information
This command is either enabled or disabled. If no OSPF process is identified as the MIB manager, the first OSPF
process is used.
If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB responsibility.
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
Syntax
network
ip-address mask
area
area-id
To disable an OSPF area, use the
no network
ip-address mask
area
area-id
command.
Parameters
ip-address
Specify a primary or secondary address in dotted decimal format. The primary address is
required before adding the secondary address.
mask
Enter a network mask in /prefix format. (/x)
area-id
Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal value
range is from 0 to 65535. IP address format is dotted decimal format A.B.C.D.
NOTE:
If the area ID is smaller than 65535, it is converted to a decimal value.
For example, if you use an area ID of 0.0.0.1, it is converted to 1.
Command Modes
ROUTER OSPF
1102
Open Shortest Path First (OSPFv2 and OSPFv3)
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...