Dell S4820T, Руководство по настройке

Страница: 481 / 1178

•
secondary
: add the keyword
secondary
if the IP address is the interface’s backup IP address.
You can configure up to eight secondary IP addresses.
Example the
show config
Command
To view the configuration, use the
show config
command in INTERFACE mode or use the
show ip
interface
command in EXEC privilege mode, as shown in the second example.
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/1
ip address 10.11.1.1/24
no shutdown
!
Configuring Static Routes
A static route is an IP address that you manually configure and that the routing protocol does not learn,
such as open shortest path first (OSPF). Often, static routes are used as backup routes in case other
dynamically learned routes are unreachable.
You can enter as many static IP addresses as necessary.
To configure a static route, use the following command.
• Configure a static IP address.
CONFIGURATION mode
ip route [vrf vrf-name ] ip-address mask { ip-address | interface [ ip-address ]}
[ distance ] [permanent] [tag tag-value ] [vrf vrf-name ]
Use the following required and optional parameters:
–
vrf vrf-name
: use the VRF option after the
ip route
keyword to configure a static route on
that particular VRF, use the VRF option after the next hop to specify which VRF the next hop
belongs to. This will be used in route leaking cases.
NOTE: For more information on route leaking, see the Route Leaking Between VRFs section.
–
ip-address
: enter an address in dotted decimal format (A.B.C.D).
–
mask
: enter a mask in slash prefix-length format (/X).
–
interface
: enter an interface type then the slot/port information.
–
distance
: the range is from 1 to 255. (optional)
–
permanent
: keep the static route in the routing table (if you use the
interface
option) even if
you disable the interface with the route. (optional)
–
tag tag-value
: the range is from 1 to 4294967295. (optional)
Example of the
show ip route static
Command
To view the configured routes, use the
show ip route static
command.
Dell#show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
S 2.1.2.0/24 Direct, Nu 0 0/0 00:02:30
S 6.1.2.0/24 via 6.1.20.2, Te 5/1 1/0 00:02:30
IPv4 Routing
481