Dell S4048T, Руководство по настройке

Страница: 770 / 1277

Create a Redirect List
To create a redirect list, use the following commands.
Create a redirect list by entering the list name.
CONFIGURATION mode
ip redirect-list redirect-list-name
redirect-list-name
: 16 characters.
To delete the redirect list, use the
no ip redirect-list
command.
The following example creates a redirect list by the name of
xyz
.
Dell(conf)#ip redirect-list ?
WORD Redirect-list name (max 16 chars)
Dell(conf)#ip redirect-list xyz
Create a Rule for a Redirect-list
To set the rules for the redirect list, use the following command. You can enter the command multiple times
and create a sequence of redirect rules. Use the
seq nn redirect
version of the command to organize
your rules.
Configure a rule for the redirect list.
CONF-REDIRECT-LIST mode
seq {number} redirect { ip-address | tunnel tunnel-id} [track <obj-id> }{ ip-
protocol-number | protocol-type [ bit ]} { source mask | any | host ip-address }
{ destination mask | any | host ip-address }
• number is the number in sequence to initiate this rule
• ip-address is the Forwarding router’s address
• tunnel is used to configure the tunnel settings
• tunnel-id is used to redirect the traffic
• track <obj-id> is used to track the object-id
• track is to enable the tracking
• FORMAT: A.B.C.D
• FORMAT: slot/port[/subport]
•
ip-protocol-number or protocol-type is the type of protocol to be redirected
• FORMAT: 0-255 for IP protocol number, or enter protocol type
•
source ip-address or any or host ip-address is the Source’s IP address
• FORMAT: A.B.C.D/NN, or ANY or HOST IP address
•
destination ip-address or any or host ip-address is the Destination’s IP address
• FORMAT: A.B.C.D/NN, or ANY or HOST IP address
Policy-based Routing (PBR) 770