Dell S4048T, Руководство по настройке

Страница: 459 / 1277

• Configure a primary IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
The
ip-address
must be in dotted-decimal format (A.B.C.D) and the mask must be in slash format (/xx).
Add the keyword
secondary
if the IP address is the interface’s backup IP address.
Example of the
show ip interface
Command
You can only configure one primary IP address per interface. You can configure up to 255 secondary IP
addresses on a single interface.
To view all interfaces to see with an IP address assigned, use the
show ip interfaces brief
command in
EXEC mode as shown in View Basic Interface Information .
To view IP information on an interface in Layer 3 mode, use the
show ip interface
command in EXEC
Privilege mode.
Dell>show ip int vlan 58
Vlan 58 is up, line protocol is up
Internet address is 1.1.49.1/24
Broadcast address is 1.1.49.255
Address determined by config file
MTU is 1554 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
Egress Interface Selection (EIS)
EIS allows you to isolate the management and front-end port domains by preventing switch-initiated traffic
routing between the two domains. This feature provides additional security by preventing flooding attacks on
front-end ports. The following protocols support EIS: DNS, FTP, NTP, RADIUS, sFlow, SNMP, SSH, Syslog,
TACACS, Telnet, and TFTP. This feature does not support sFlow on stacked units.
When you enable this feature, all management routes (connected, static, and default) are copied to the
management EIS routing table. Use the
management route
command to add new management routes to
the default and EIS routing tables. Use the
show ip management-eis-route
command to view the EIS
routes.
Important Points to Remember
• Deleting a management route removes the route from both the EIS routing table and the default routing
table.
• If the management port is down or route lookup fails in the management EIS routing table, the outgoing
interface is selected based on route lookup from the default routing table.
• If a route in the EIS table conflicts with a front-end port route, the front-end port route has precedence.
Interfaces 459