Dell S4048T-ON, Руководство по настройке

Страница: 97 / 1146

Example of Configuring and Verifying Port Authentication
The following example shows configuration information for a port for which the authenticator re-transmits an EAP Request Identity frame:
• after 90 seconds and a maximum of 10 times for an unresponsive supplicant
• re-transmits an EAP Request Identity frame
The bold lines show the new re-transmit interval, new quiet period, and new maximum re-transmissions.
Dell(conf-if-range-Te-2/1)#dot1x tx-period 90
Dell(conf-if-range-Te-2/1)#dot1x max-eap-req 10
Dell(conf-if-range-Te-2/1)#dot1x quiet-period 120
Dell#show dot1x interface TenGigabitEthernet 2/1
802.1x information on Te 2/1:
-----------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: UNAUTHORIZED
Re-Authentication: Disable
Untagged VLAN id: None
Tx Period: 90 seconds
Quiet Period: 120 seconds
ReAuth Max: 2
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 3600 seconds
Max-EAP-Req: 10
Auth Type: SINGLE_HOST
Auth PAE State: Initialize
Backend State: Initialize
Forcibly Authorizing or Unauthorizing a Port
The 802.1X ports can be placed into any of the three states:
• ForceAuthorized — an authorized state. A device connected to this port in this state is never subjected to the authentication process,
but is allowed to communicate on the network. Placing the port in this state is same as disabling 802.1X on the port.
• ForceUnauthorized — an unauthorized state. A device connected to a port in this state is never subjected to the authentication
process and is not allowed to communicate on the network. Placing the port in this state is the same as shutting down the port. Any
attempt by the supplicant to initiate authentication is ignored.
• Auto — an unauthorized state by default. A device connected to this port in this state is subjected to the authentication process. If the
process is successful, the port is authorized and the connected device can communicate on the network. All ports are placed in the
Auto state by default.
To set the port state, use the following command.
• Place a port in the ForceAuthorized, ForceUnauthorized, or Auto state.
INTERFACE mode
dot1x port-control {force-authorized | force-unauthorized | auto}
The default state is auto .
Example of Placing a Port in Force-Authorized State and Viewing the Configuration
The example shows configuration information for a port that has been force-authorized.
The bold line shows the new port-control state.
Dell(conf-if-Te-1/1)#dot1x port-control force-authorized
Dell(conf-if-Te-1/1)#show dot1x interface TenGigabitEthernet 1/1
802.1x information on Te 1/1:
-----------------------------
Dot1x Status: Enable
802.1X 97