Dell S4048T-ON, Руководство по настройке

Страница: 58 / 1146

Managing the File System
The Dell Networking system can use the internal Flash, external Flash, or remote devices to store files.
The system stores files on the internal Flash by default but can be configured to store files elsewhere.
To view file system information, use the following command.
• View information about each file system.
EXEC Privilege mode
show file-systems
The output of the
show file-systems
command in the following example shows the total capacity, amount of free memory, file
structure, media type, read/write privileges for each storage device in use.
Dell#show file-systems
Size(b) Free(b) Feature Type Flags Prefixes
520962048 213778432 dosFs2.0 USERFLASH rw flash:
127772672 21936128 dosFs2.0 USERFLASH rw slot0:
- - - network rw ftp:
- - - network rw tftp:
- - - network rw scp:
You can change the default file system so that file management commands apply to a particular device or memory.
To change the default directory, use the following command.
• Change the default directory.
EXEC Privilege mode
cd directory
Enabling Software Features on Devices Using a
Command Option
The capability to activate software applications or components on a device using a command is supported on this platform.
Starting with Release 9.4(0.0), you can enable or disable specific software features or applications that need to run on a device by using a
command attribute in the CLI interface. This enables effective, streamlined management and administration of applications and utilities that
run on a device. You can employ this capability to perform an on-demand activation, or turn-off a software component or protocol. A
feature configuration file generated for each image contains feature names, and denotes if this enabling or disabling method is available. You
can enable or disable the VRF application globally across the system by using this capability.
Activate the VRF application on a device by using the
feature vrf
command in CONFIGURATION mode.
NOTE: The
no feature vrf
command is not supported on any of the platforms.
To enable the VRF feature and cause all VRF-related commands to be available or viewable in the CLI interface, use the following
command. You must enable the VRF feature before you can configure its related attributes.
Dell(conf)# feature vrf
Based on if the VRF feature is identified as supported in the Feature Configuration file, configuration command
feature vrf
becomes
available for usage. This command is stored in the running-configuration and precedes all other VRF-related configurations.
To display the state of Dell Networking OS features:
Dell# show feature
58 Getting Started