Dell S4048-ON, Руководство по настройке

Страница: 750 / 1039

Monitoring
To view information on transactions, use the following command.
• View transactions to troubleshoot problems.
EXEC Privilege mode
debug
Remote Authentication
The system takes the access class from the server. Access class is the class of service that restricts Telnet access and
packet sizes.
If you have configured remote authorization, the system ignores the access class you have configured for the VTY line and gets this
access class information from the server. The system must know the username and password of the incoming user before
it can fetch the access class from the server. A user, therefore, at least sees the login prompt. If the access class denies the
connection, the system closes the Telnet session immediately. The following example demonstrates how to configure the access-
class from a server. This configuration ignores the configured access-class on the VTY line. If you have configured a
deny10 ACL on the server, the system downloads it and applies it. If the user is found to be coming from the 10.0.0.0
subnet, the system also immediately closes the Telnet connection. Note, that no matter where the user is coming from, they see the
login prompt.
When configuring a server host, you can set different communication parameters, such as the key password.
Example of Specifying a Server Host
Dell(conf)#
Dell(conf)#aaa authentication login tacacsmethod
Dell(conf)#aaa authentication exec tacacsauthorization
Dell(conf)#tacacs-server host 25.1.1.2 key Force
Dell(conf)#
Dell(conf)#line vty 0 9
Dell(config-line-vty)#login authentication tacacsmethod
Dell(config-line-vty)#end
Specifying a Server Host
To specify a server host and configure its communication parameters, use the following command.
• Enter the host name or IP address of the server host.
CONFIGURATION mode
tacacs-server host { hostname | ip-address } [port port-number ] [timeout seconds ] [key key ]
Configure the optional communication parameters for the specific host:
–
port port-number
: the range is from 0 to 65535. Enter a TCP port number. The default is 49 .
–
timeout seconds
: the range is from 0 to 1000. Default is 10 seconds .
–
key key
: enter a string for the key. The key can be up to 42 characters long. This key must match a key configured on the
server host. This parameter must be the last parameter you configure.
If you do not configure these optional parameters, the default global values are applied.
Example of Connecting with a Server Host
To specify multiple server hosts, configure the
tacacs-server host
command multiple times. If you configure
multiple server hosts, Dell Networking OS attempts to connect with them in the order in which they were configured.
To view the configuration, use the
show running-config
command in EXEC Privilege mode.
750
Security