Dell S4048-ON, Руководство по настройке

Страница: 504 / 1039

no Negate a command or set its defaults
show Show LLDP configuration
Dell(conf-lldp)#exit
Dell(conf)#interface tengigabitethernet 1/3
Dell(conf-if-te-1/3)#protocol lldp
Dell(conf-if-te-1/3-lldp)#?
advertise Advertise TLVs
disable Disable LLDP protocol on this interface
end Exit from configuration mode
exit Exit from LLDP configuration mode
hello LLDP hello configuration
mode LLDP mode configuration (default = rx and tx)
multiplier LLDP multiplier configuration
no Negate a command or set its defaults
show Show LLDP configuration
Dell(conf-if-te-1/3-lldp)#
Enabling LLDP
LLDP is enabled by default. Enable and disable LLDP globally or per interface. If you enable LLDP globally, all UP interfaces send
periodic LLDPDUs.
To enable LLDP, use the following command.
1. Enter Protocol LLDP mode.
CONFIGURATION or INTERFACE mode
protocol lldp
2. Enable LLDP.
PROTOCOL LLDP mode
no disable
Disabling and Undoing LLDP
To disable or undo LLDP, use the following command.
• Disable LLDP globally or for an interface.
disable
To undo an LLDP configuration, precede the relevant command with the keyword
no
.
Enabling LLDP on Management Ports
LLDP on management ports is enabled by default.
To enable LLDP on management ports, use the following command.
1. Enter Protocol LLDP mode.
CONFIGURATION mode
protocol lldp
2. Enable LLDP.
PROTOCOL LLDP mode
no disable
504
Link Layer Discovery Protocol (LLDP)