Dell QLogic QL45212, Руководство пользователя, Страница: 86 / 101

8–Troubleshooting
Testing Network Connectivity
71 BC0154503-00 B
If you loaded a new driver, but have not yet booted, the
modinfo
command will
not show the updated driver information. Instead, type the following
dmesg
command to view the logs. In this example, the last entry identifies the driver that
will be active upon reboot.
# dmesg | grep -i "QLogic" | grep -i "qede"
[ 10.097526] QLogic FastLinQ 4xxxx Ethernet Driver qede x.x.x.x
[ 23.093526] QLogic FastLinQ 4xxxx Ethernet Driver qede x.x.x.x
[ 34.975396] QLogic FastLinQ 4xxxx Ethernet Driver qede x.x.x.x
[ 34.975896] QLogic FastLinQ 4xxxx Ethernet Driver qede x.x.x.x
[ 3334.975896] QLogic FastLinQ 4xxxx Ethernet Driver qede x.x.x.x
Testing Network Connectivity
Network Connectivity Testing for Windows
Network connectivity can be tested using the
ping
command to determine if the
network connection is working.
1. Click Start , and then click Run .
2. Type
cmd
in the Open box, and then click OK .
3. Type
ipconfig /all
to view the network connection to be tested.
4. Type
ping < ip_address >
, and then press ENTER.
The ping statistics that are displayed indicate whether the network connection is
working or not.
The adapter link speed can be forced to 10Gbps or 25Gbps using the following
methods:

QConvergeConsole
®
GUI:
Network Adapter , Advanced Properties—Speed & Duplex settings

QCS CLI:
qcscli –t ndis –f bdf –i <bus:device.function number of
port> “cfg advanced \”speed \”&\” duplex\”=\”10 gbps
full duplex\””
NOTE
When using forced link speeds, verify that both the adapter and the switch
are forced to the same speed.