Slide the tape drive into the open bay, aligning the tray or rails with the slots in the bay. A "generic" host system with several unused bays is shown in
Figure 5
. If your
system does not require mounting hardware, check that the holes in the system's chassis are aligned with the holes in the side of the tape drive.
Do not fully secure the drive yet; you may have to move it to connect the power and SCSI cables.
Step 6: Attach Power and SCSI Cables
Figure 6. Power and SCSI Cable Connectors
A red dot in the illustration denotes Pin 1 on the jumper block or connector.
Attach a spare power cable from the computer system's internal power supply to the power connector, as shown in
Figure 6
, upper left. Attach a spare SCSI connector on the
system's SCSI ribbon cable to the SCSI connector, as shown in
Figure 7
. (The location of the SCSI connector on the back of the drive is shown in
Figure 6
, lower right.)
Figure 7. Attach the SCSI Connector
Содержание PowerVault 110T SDLT320
Страница 5: ...Back to Contents Page ...
Страница 18: ......
Страница 22: ...Back to Contents Page ...