CAUTION: While removing or reinstalling the processor, wipe your hands of any
contaminants. Contaminants on the processor pins such as thermal grease or oil can damage
the processor.
7.
Align the processor with the socket keys.
CAUTION: Do not use force to seat the processor. When the processor is positioned
correctly, it engages easily into the socket.
8.
Align the pin-1 indicator of the processor with the triangle on the system board. .
CAUTION: Do not use force to seat the processor. When the processor is positioned
correctly, it engages easily into the socket.
9.
Place the processor on the socket such that the slots on the processor align with the socket keys.
10.
Close the processor shield.
11.
Lower the
close first
socket-release lever near the lock icon
and push it under the tab to lock it.
12.
Similarly, lower the
open first
socket-release lever near the unlock icon
and push it under the tab
to lock it.
Next steps
NOTE: Ensure that you install the heat sink after you install the processor. The heat sink is necessary
to maintain proper thermal conditions.
1.
Install the heat sink.
2.
If removed, reinstall the PCIe expansion card riser.
3.
If disconnected, reconnect the cables to the expansion card(s).
4.
While booting, press F2 to enter System Setup and verify that the processor information matches the
new system configuration.
5.
Run the system diagnostics to verify that the new processor operates correctly.
Related Links
Safety instructions
Removing the cooling shroud
Removing the control panel assembly
Removing a processor
After working inside your system
Installing a heat sink
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Keep the Phillips #2 screwdriver ready.
3.
Follow the procedure listed in the Before working inside your system section.
4.
If installed, remove the cooling fan assembly.
5.
If installed, remove the full-length PCIe card.
146
