Removing a memory module
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in the
Before working inside your system
3.
.
WARNING:
The memory modules are hot to touch for some time after the system has been powered off. Allow
the memory modules to cool before handling them.
NOTE:
To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not
occupied. Remove memory module blanks only if you intend to install memory modules in those sockets.
Steps
1. Locate the appropriate memory module socket.
2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module
socket to fully open.
CAUTION:
Handle each memory module only by the card edges, ensuring not to touch the middle of the
memory module or metallic contacts.
3. Lift the memory module away from the system.
Figure 43. Removing a memory module
Next steps
1.
2. If you are removing the memory module permanently, install a memory module blank. The procedure to install a memory
module blank is similar to that of the memory module.
NOTE:
When operating your system with single processor, install memory module blanks in processor 2 memory
sockets.
.
52
Installing and removing system components
Содержание PowerEdge R450
Страница 15: ...Figure 11 Memory information Dell EMC PowerEdge R450 system overview 15 ...
Страница 16: ...Figure 12 Service information electrical overview 16 Dell EMC PowerEdge R450 system overview ...
Страница 17: ...Figure 13 Service information mechanical overview Dell EMC PowerEdge R450 system overview 17 ...
