Dell PowerEdge R410, Руководство владельца оборудования

Страница: 128 / 190

128
Installing System Components
10
Rotate the processor shield upward and out of the way. See Figure 3-23.
11
Lift the processor out of the socket and leave the release lever up so that
the socket is ready for the new processor.
CAUTION:
Be careful not to bend any of the pins on the ZIF socket when removing
the processor. Bending the pins can permanently damage the system board.
If you are permanently removing a processor from socket CPU2, you must
install a processor blank and a heat-sink blank to ensure proper system
cooling. Adding the blanks is similar to adding a processor. See "Installing a
Processor" on page 129.
NOTE:
In single-processor configurations, a processor must be installed in socket
CPU1. Install the blanks in socket CPU2 only.
Figure 3-23. Installing and Removing a Processor
1 processor 2 processor shield
3 notch in processor 4 socket key
5 ZIF socket 6 socket-release lever
6
5
1 2
4
3
book.book Page 128 Tuesday, March 31, 2009 5:26 PM