8
Next Steps
You can customize the aggregator for use in your data center network. To perform additional switch
configuration, do one of the following:
• For remote out-of-band management (OOB), enter the OOB management interface IP address into a
Telnet or secure shell (SSH) client and log in to the switch using the user ID and password to access
the CLI.
• For local management using the CLI, use the attached console connection.
• For remote in-band management from a network management station, enter the IP address of the
default VLAN and log in to the switch to access the CLI.
• In case of a Dell Networking OS upgrade, you can check to see that the aggregator is running the
latest Dell Networking OS version by entering the
show version
command.
For information about how to configure software features, refer to the
Configuration Guide for the Dell
PowerEdge FN 410S I/O Aggregator
on the Dell Support website at
Next Steps
27
