Dell PowerConnect M6220, Руководство по настройке пользователя

Страница: 1096 / 1294

1096
Configuring IPv6 Routing
Configuring IPv6 Interface Settings
Beginning in Privileged EXEC mode, use the following commands to
configure IPv6 settings for VLAN, tunnel, or loopback interfaces.
Command Purpose
configure
Enter Global Configuration mode.
interface {vlan |
tunnel | loopback}
interface-id
Enter Interface Configuration mode for the specified VLAN,
tunnel, or loopback interface.
ipv6 enable
Enable IPv6 on the interface. Configuring an IPv6 address
will automatically enable IPv6 on the interface.
ipv6 address
{autoconfig | dhcp |
prefix/prefix-length
[
eui64
]}
Configure the IPv6 address and network prefix length.
Setting an IPv6 address enables IPv6 on the interface. You
can also use the ipv6 enable command to enable IPv6 on the
interface without setting an address.
Link-local, multicast, IPv4-compatible, and IPv4-mapped
addresses are not allowed to be configured.
Include the
EUI-64 keyword to have the system add the 64-
bit interface ID to the address. You must use a network prefix
length of 64 in this case.
For VLAN interfaces, use the
dhcp
keyword to enable the
DHCPv6 client and obtain an IP address form a network
DHCPv6 server.
ipv6 mtu size (VLAN interfaces only) Set the IPv6 Maximum
Transmission Unit (MTU) on a routing interface. The IPv6
MTU is the size of the largest IPv6 packet that can be
transmitted on the interface without fragmentation. The
range is 1280–1500 bytes.
ipv6 traffic-filter ACL
name
Add an access-list filter to this interface.
ipv6 unreachables (VLAN interfaces only) Allow the interface to send ICMPv6
Destination Unreachable messages. The
no ipv6
unreachables command suppresses the ICMPv6 unreachable
messages for this interface.
exit
Exit the interface configuration mode.