Dell PowerConnect J-EX8208, Руководство пользователя программного обеспечения

Страница: 869 / 3660

Configuring the Virtual Management Ethernet Interface for Global Management of a
Virtual Chassis (CLI Procedure)
If you want to configure and manage a Virtual Chassis remotely through SSH or Telnet,
configure the virtual management Ethernet (VME) interface on the master of the Virtual
Chassis. You can configure and manage all members of the Virtual Chassis through this
single global interface.
1.
Power on the switch that you want to function as the master.
2.
Check the front-panel LCD to confirm that the switch has powered on correctly.
3.
Run the EZ Setup program on the switch, specifying the identification parameters.
See “Connecting and Configuring a J-EX Series Switch (CLI Procedure)” on page 161
or “Connecting and Configuring a J-EX Series Switch (J-Web Procedure)” on page 163
for details.
To configure the VME:
[edit]
user@SWA-0#
set interfaces vme unit 0 family inet address /ip-address/mask/
Related
Documentation
Example: Configuring a Virtual Chassis with a Master and Backup in a Single Wiring
Closet on page 717
•
•
Understanding Global Management of a Virtual Chassis Configuration on page 699
Configuring the Timer for the Backup Member to Start Using Its Own MAC Address, as
Master of Virtual Chassis (CLI Procedure)
When a backup member takes control of a Virtual Chassis configuration because of a
reset or other temporary failure, the backup uses the MAC address of the old master.
This helps to ensure a smooth transition of mastership with no disruption to network
connectivity.
The MAC persistence timer is used in situations when the master is no longer a member
of the Virtual Chassis configuration, because it has been physically disconnected or
removed. If the old master does not rejoin the Virtual Chassis configuration before the
timer elapses, the new master starts using its own MAC address.
The default timer value is 10 minutes. There are no minimum or maximum limits.
Before you begin configuring the timer, ensure that you have at least two member switches
in the Virtual Chassis configuration. To configure or modify the MAC persistence timer,
use the following command:
[edit virtual-chassis]
user@switch#
set mac-persistence-timer 30
This command modifies the MAC persistence timer value to specify a timer value of 30
minutes rather than the default timer value of 10 minutes.
797
Chapter 45: Configuring Virtual Chassis