Steps
1. Align the notch on the solid-state drive with the tab on the SSD2 slot.
2. Slide the solid-state drive into the SSD2 slot.
3. Using the alignment post, place the solid-state drive thermal bracket over the solid-state drive.
4. Align the screw hole on the solid-state drive thermal bracket with the screw hole on the system board.
5. Replace the screw (M2x4) that secures the solid-state drive thermal bracket and the solid-state drive to the system board.
Next steps
1. Install the
2. Install the
.
After working inside your computer
.
Fans
Removing the right fan
Prerequisites
Before working inside your computer
.
2. Remove the
.
About this task
The following image indicates the location of the right fan and provides a visual representation of the removal procedure.
NOTE:
The fan depicted is for systems with a discrete graphics card, the fan for systems with an integrated graphics card
may appear different but installs in the same manner.
28
Removing and installing components
Содержание P92F
