Steps
1. Place the heat-sink on the system board.
2. Align the screw holes on the heat sink to the screw holes on the system board.
3. In sequential order (1 > 2 > 3 > 4 > 5 > 6 > 7) tighten the seven captive screws that secure the heat sink to the system
board.
NOTE:
The number of screws varies depending on the configuration ordered.
Next steps
1. Install the
.
2. Exit
.
After working inside your computer
.
Power button with optional fingerprint reader
Removing the power button with optional fingerprint reader
Prerequisites
Before working inside your computer
.
2. Enter
.
3. Remove the
.
4. Remove the
.
About this task
The following image(s) indicate the location of the power button with optional fingerprint reader and provides a visual
representation of the removal procedure.
50
Removing and installing components
Содержание P157G
Страница 14: ...14 Removing and installing components ...