Dell P157G, Руководство по обслуживанию

Страница: 33 / 74

Next steps
1. Install the base cover .
2. Exit Service Mode .
3. Follow the procedure in After working inside your computer .
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Enter Service Mode .
3. Remove the base cover .
4. Remove the display assembly .
About this task
The following image(s) indicate the location of the power-adapter port and provides a visual representation of the removal
procedure.
Steps
1. Remove the two screws (M2.5x4) that secure the right display hinge to the system board.
2. Open the display hinge at an angle of 90 degrees.
3. Disconnect the power-adapter port cable from the system board.
4. Peel the tape that secures the power-adapter port cable to the system board.
5. Remove the power-adapter port cable from the routing guide on the palm-rest and keyboard assembly.
6. Lift the power-adapter port, along with its cable, off the palm-rest and keyboard assembly.
Removing and installing components 33