Messages and Codes
2-3
Diskette write
protected
The diskette write-protect feature is
activated.
Remove the diskette from drive A and move the
write-protect tab to the unlocked position.
Gate A20
failure
One or more SIMMs or DIMMs may
be loose.
See “Troubleshooting System Memory” in
Chapter 6.
General
failure
The operating system is unable to
carry out the command.
This message is usually followed by specific infor-
mation—for example,
PRINTER OUT OF
PAPER
. Respond by taking the appropriate action.
Hard disk
configuration
error
The hard-disk drive failed
initialization.
See “Troubleshooting Hard-Disk Drives” in
Chapter 6.
Hard disk
controller
failure
Hard disk
failure
Hard-disk drive
read failure
The hard-disk drive failed
initialization.
See “Troubleshooting Hard-Disk Drives” in
Chapter 6.
Incompatible
Processor: CPU0
is B0
step or below!
Incompatible
Processor: CPU1
is B0
step or below!
An old, unsupported version of the
microprocessor is installed.
In a single-microprocessor system,
CPU0 refers to the system board
microprocessor; in a dual-
microprocessor system, it refers to
the secondary microprocessor on the
add-in card.
The CPU1 message appears only on
a dual-microprocessor system and
always refers to the system board
microprocessor.
Replace the indicated microprocessor with a cur-
rent version of the microprocessor. If you need
technical assistance, see Chapter 7, “Getting
Help.”
NOTE: These messages indicate a fatal error.
When a fatal error occurs, the system usually can-
not be rebooted until an appropriate hardware
change has been made.
Table 2-1. System Messages (continued)
Message
Cause
Action
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and acronym list that precedes the
Index.
Содержание OptiPlex E1
