Table 24. Video
Option
Description
●
Auto (default)
●
Intel HD Graphics
NOTE:
If you do not select Auto, the on-board graphics device will be present and
enabled.
Security
Table 25. Security
Option
Description
Admin Password
Allows you to set, change, and delete the admin password.
System Password
Allows you to set, change, and delete the system password.
Internal HDD-0 Password
Allows you to set, change, and delete the computer’s internal hard drive password.
Password Configuration
Allows you to control the minimum and maximum number of characters that are allowed for
an administrative password and the system password. The range of characters is between 4
and 32.
Password Bypass
This option lets you bypass the System (Boot) Password and the internal hard drive
password prompts during a system restart.
●
Disabled — Always prompt for the system and internal HDD password when they are set.
This option is disabled by default.
●
Reboot Bypass — Bypass the password prompts on Restarts (warm boots).
NOTE:
The system will always prompt for the system and internal HDD passwords when
powered on from the off state (a cold boot). Also, the system will always prompt for
passwords on any module bay HDDs that may be present.
Password Change
This option lets you determine whether changes to the System and Hard Disk passwords are
permitted when an administrator password is set.
Allow Non-Admin Password Changes
- This option is enabled by default.
UEFI Capsule Firmware
Updates
This option controls whether this system allows BIOS updates via UEFI capsule update
packages. This option is selected by default. Disabling this option will block BIOS updates
from services such as Microsoft Windows Update and Linux Vendor Firmware Service
(LVFS).
TPM 2.0 Security
Allows you to control whether the Trusted Platform Module (TPM) is visible to the operating
system.
●
TPM On (default)
●
Clear
●
PPI Bypass for Enable Commands
●
PPI Bypass for Disable Commands
●
PPI Bypass for Clear Commands
●
Attestation Enable (default)
●
Key Storage Enable (default)
●
SHA-256 (default)
Choose any one option:
●
Disabled
●
Enabled (default)
Absolute
This field lets you Enable, Disable or permanently Disable the BIOS module interface of the
optional Absolute Persistence Module service from Absolute Software.
●
Enabled - This option is selected by default.
●
Disable
28
System setup
