3. Install the following components:
a)
b)
c)
4. Follow the procedure in
After working inside your computer
.
Processor
Removing the processor
1. Follow the procedure in
Before working inside your computer
.
2. Remove the following components:
a)
b)
c)
d)
3. To remove the processor:
a) Release the socket lever by pushing the lever down and out from under the tab on the processor shield [1].
b) Lift the lever upward, and lift the processor shield [2].
CAUTION:
The processor socket pins are fragile and can be permanently damaged. Be careful not to bend the
pins in the processor socket when removing the processor out of the socket.
c) Lift the processor and remove it from the processor socket [3].
NOTE:
After removing the processor, place it in an antistatic container for reuse, return, or temporary storage.
Do not touch the bottom of the processor to avoid damage to the processor contacts. Touch only the side edges
of the processor.
Removing and Installing components
51
Содержание OptiPlex 5270 All-in-One
Страница 1: ...Dell OptiPlex 5270 All in One Service Manual Regulatory Model W20B Regulatory Type W20B001 ...
Страница 42: ...4 Lift the heat sink off the system board and display assembly base 42 Removing and Installing components ...
Страница 54: ...4 Pry and lift the base cover off the middle frame 54 Removing and Installing components ...
Страница 58: ...b Slide the PSU and lift it away from the chassis 58 Removing and Installing components ...
