Dell Networking S6000 System, Справочное руководство

Страница: 894 / 1510

fefd-global
Enable FEFD globally on the system.
S6000
Syntax
fefd-global [interval seconds ][mode {normal | aggressive}]
To disable FEFD globally, use the
no fefd-global [mode {normal |
aggressive}]
command.
Parameters
interval
seconds
Enter the keyword
interval
followed by the number of
seconds to wait between FEFD control packets. Range is
from 3 to 300 seconds. Default is 15 seconds.
normal (OPTIONAL) Enter the keywords
mode normal
to change
the link state to “unknown” when a far-end failure the
software detects on that interface. When the interface is
placed in “unknown” state, the software brings down the line
protocol. The default is
Normal mode .
aggressive (OPTIONAL) Enter the keywords
mode aggressive
to
change the link state to “error-disabled” when a far-end
failure the software detects on that interface. When an
interface is placed in “error-disabled” state, t enter the
fefd
reset
command to reset the interface state.
Defaults Disabled.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.12.0 Introduced on the S4810.
Legacy E-
Series
command.
Usage
Information
If you enter only the
fefd-global
syntax, the mode is normal and the default
interval is 15 seconds.
894
Layer 2