Dell Networking S6000 System, Справочное руководство

Страница: 824 / 1510

isis priority
Set the priority of the designated router you select.
S6000
Syntax
isis priority value [level-1 | level-2]
To return to the default values, use the
no isis priority [ value ] [level-1
| level-2]
command.
Parameters
value This value sets the router priority. The higher the value, the
higher the priority. The range is from 0 to 127. The default is
64 .
level-1 (OPTIONAL) Specify the priority for Level 1. This setting is the
default.
level-2 (OPTIONAL) Specify the priority for Level 2.
Defaults value = 64 ; level-1 (if not otherwise specified).
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OSCommand Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information
You can configure priorities independently for Level 1 and Level 2. Priorities
determine which router on a LAN is the designated router. Priorities are advertised
within hellos. The router with the highest priority becomes the designated
intermediate system (DIS).
NOTE: Routers with a priority of 0 cannot be a designated router.
Setting the priority to 0 lowers the chance of this system becoming the DIS, but
does not prevent it. If all the routers have priority 0, one with highest MAC address
becomes DIS even though its priority is 0.
824
Intermediate System to Intermediate System (IS-IS)