Dell Networking S6000 System, Справочное руководство

Страница: 691 / 1510

the members have a link MTU of 2100 and an IP MTU 2000, the Port Channel’s
MTU values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.
When an interface is removed from a Port Channel with the
no channel-member
command, the interface reverts to its configuration prior to joining the Port
Channel.
An interface can belong to only one Port Channel.
On the E-Series TeraScale, you can add up to 16 interfaces to a Port Channel; E-
Series ExaScale can add up to 64. You can have eight interfaces per Port Channel
on the C-Series and S-Series. The interfaces can be located on different line cards
but must be the same physical type and speed (for example, all 1-Gigabit Ethernet
interfaces). However, you can combine 100/1000 interfaces and GE interfaces in
the same Port Channel.
If the Port Channel contains a mix of interfaces with 100 Mb/s speed and 1000
Mb/s speed, the software disables those interfaces whose speed does not match
the speed of the first interface configured and enabled in the Port Channel. If that
first interface goes down, the Port Channel does not change its designated speed;
disable and re-enable the Port Channel or change the order of the channel
members configuration to change the designated speed. If the Port Channel
contains a mix of interfaces with 100 Mb/s speed and 1000 Mb/s speed, the
software disables those interfaces whose speed does not match the speed of the
first interface configured and enabled in the Port Channel. If that first interface
goes down, the Port Channel does not change its designated speed; disable and
re-enable the Port Channel or change the order of the channel members
configuration to change the designated speed. For more information about Port
Channels, refer to the
Dell Networking OS Configuration Guide .
Related
Commands
description — assigns a descriptive text string to the interface.
interface port-channel — creates a Port Channel interface.
shutdown — disables/enables the port channel.
group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
S6000
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the
no group group_number
command.
Parameters
group_number Enter an integer from 1 to 32 that uniquely identifies this LAG
fate-sharing group.
Interfaces
691