Dell Networking S6000 System, Справочное руководство

Страница: 343 / 1510

compares MED between adjacent paths within an AS group because all paths in the
AS group are from the same AS.
When you change the path selection from Deterministic to Non-Deterministic, the
path selection for the existing paths remains Deterministic until you enter the
clear ip bgp
command to clear existing paths.
bgp recursive-bgp-next-hop
Enable next-hop resolution through other routes learned by BGP.
S6000
Syntax
bgp recursive-bgp-next-hop
To disable next-hop resolution, use the
no bgp recursive-bgp-next-hop
command.
Defaults Enabled
Command
Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.2.1.0 Introduced.
Usage
Information
This command is a knob to disable BGP next-hop resolution using BGP learned
routes. During the next-hop resolution, only the first route that the next-hop
resolves through is verified for the route’s protocol source and is checked if the
route is learned from BGP or not.
The
clear ip bgp
command is required for this command to take effect and to
keep the BGP database consistent. Execute the
clear ip bgp
command right
after executing this command.
Border Gateway Protocol
343