Dell Networking S6000 System, Справочное руководство

Страница: 254 / 1510

external Enter the keyword
external
to assign the IS-IS external
metric.
type-1 Enter the keyword
type-1
to assign the OSPF Type 1 metric.
type-2 Enter the keyword
type-2
to assign the OSPF Type 2 metric.
Defaults Not configured.
Command
Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Implemented the keyword
internal
.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Related
Commands
set automatic-tag — computes the tag value of the route.
set level — specifies the OSPF area for route redistribution.
set metric — specifies the metric value assigned to redistributed routes.
set tag — specifies the tag assigned to redistributed routes.
set next-hop
To specify an IP address as the next hop, configure a filter.
S6000
Syntax
set next-hop ip-address
To delete the setting, use the
no set next-hop ip-address
command.
254
Access Control Lists (ACL)