Dell Networking S6000 System, Справочное руководство

Страница: 177 / 1510

seq 5 deny ip any 191.1.0.0 /16 count (0x00 packets)
seq 10 deny ip any 191.2.0.0 /16 order 4
seq 15 deny ip any 191.3.0.0 /16
seq 20 deny ip any 191.4.0.0 /16
seq 25 deny ip any 191.5.0.0 /16
Dell#show ip accounting access-list L3-ACL vrf vrf3
!
Standard Ingress IP access list L3-ACL on vrf3
Total cam count 3
seq 5 permit 10.1.2.0/24
seq 10 permit 20.1.2.0/24
seq 15 permit 30.1.2.0/24
Dell#
Standard IP ACL Commands
When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an
implicit permit.
The S6000 supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands
sections.
deny
To drop packets with a certain IP address, configure a filter.
S6000
Syntax
deny { source | any | host { ip-address }}
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s
sequence number.
• Use the
no deny { source [ mask ] | any | host ip-address }
command.
Parameters
source Enter the IP address in dotted decimal format of the network
from which the packet was sent.
any Enter the keyword
any
to specify that all routes are subject
to the filter. You can enter any of the following keywords to
specify route types.
•
bytes
— Enter the keyword
count
to count packets the
filter processes.
•
count
— Enter the keyword
bytesorder
to count bytes
the filter processes.
Access Control Lists (ACL)
177