Dell Networking S6000 System, Справочное руководство

Страница: 1283 / 1510

ip ssh authentication-retries
Configure the maximum number of attempts that should be used to authenticate a user.
S6000
Syntax
ip ssh authentication-retries 1-10
Parameters
1-10 Enter the number of maximum retries to authenticate a user.
The range is from 1 to 10. The default is
3 .
Defaults 3
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Usage
Information This command specifies the maximum number of attempts to authenticate a user
on an SSH connection with the remote host for password authentication. SSH
disconnects when the number of password failures exceeds authentication-retries.
ip ssh connection-rate-limit
Configure the maximum number of incoming SSH connections per minute.
S6000
Syntax
ip ssh connection-rate-limit 1-10
Parameters
1-10 Enter the number of maximum numbers of incoming SSH
connections allowed per minute. The range is from 1 to 10
per minute. The default is
10 per minute .
Security
1283