Dell Networking S6000 System, Справочное руководство

Страница: 1113 / 1510

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
On 40-port 10G stack-unit if the traffic is shaped between 64 and 1000 Kbs, for
some values, the shaped rate is much less than the value configured.
NOTE: When packets of size greater than 7000 bytes are expected to be
received from the network, Dell Networking recommends that you configure
the burst value to be more than 175 KB if you configured the rate shape. Such
a setting ensures proper bandwidth sharing across queues.
Related
Commands rate-shape — shapes traffic output as part of the designated policy.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all
interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE
mode entry.
S6000
Syntax
service-class dynamic dot1p
To return to the default setting, use the
no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the
service-class
dynamic dot1p
command. The default mapping is as follows:
dot1p Queue ID
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Command
Modes
• INTERFACE
• CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
Quality of Service (QoS)
1113