Layer 2 Switching Commands
614
The following table explains the output parameters.
Examples
console#show mvr members
MVR Group IP Status Members
------------------ --------------- ---------------------
224.1.1.1 INACTIVE Gi1/0/1, Gi1/0/2, Gi1/0/3
console#show mvr members 224.1.1.1
MVR Group IP Status Members
------------------ --------------- ---------------------
224.1.1.1 INACTIVE Gi1/0/1, Gi1/0/2, Gi1/0/3
show mvr interface
Use the
show mvr interface
command to display the MVR enabled interfaces
configuration.
Syntax
show mvr interface
[interface-id
[
members
[
vlan
vlan-id]]]
• interface-id—Identifies a specific interface.
• vlan-id—VLAN identifier.
Default Configuration
This command has no default configuration.
Message Type
Message Description
Successful Completion Message
None
Error Completion Message
MVR disabled
Parameter
Description
MVR Group IP
MVR group multicast IP address.
Status
The status of the specific MVR group. It can
be active or inactive.
Members
The list of ports which participates in the
specific MVR group.
Содержание N1100-ON
