Dell N1100-ON, Справочное руководство

Страница: 588 / 2332

Layer 2 Switching Commands
588
• Value—The local switch priority value. (The range is 1-255.)
Default Configuration
The default priority value is 100.
Command Modes
MLAG Domain Configuration mode
User Guidelines
This value is used for the MLAG role election and is sent to the MLAG peer
in the MLAG keepalive messages. The MLAG switch with the numerically
lower priority value becomes the Primary and the switch with higher priority
becomes the Secondary. If both the MLAG peer switches have the same role
priority, the device with lower system MAC address becomes the Primary
switch.
Changes to the priority value are not preemptive. The keepalive role selection
state machine is not restarted even if the keepalive priority is modified post
election. This means that priority value changes in a running MLAG domain
do not affect the selection of the primary and secondary switches. In order for
changes to take effect, disable the VPC with the no feature vpc command
and re-enable it.
Example
console(config-vpc 1)#role priority 30
show vpc
Use the show vpc command to display MLAG information. The
configuration and operational modes of the MLAG are displayed. The MLAG
is operationally enabled if all preconditions are met. The port channel
configured as an MLAG interface is also displayed along with the member
ports on the current switch and peer switch (plus their link status).
Syntax
show vpc id
• id—A valid MLAG identifier.