Dell N1100-ON, Справочное руководство

Страница: 360 / 2332

Layer 2 Switching Commands
360
ipv6 dhcp snooping trust
Use the ipv6 dhcp snooping trust command to configure an interface as
trusted. Use the no form of the command to return the interface to the
default configuration.
Syntax
ipv6 dhcp snooping trust
no ipv6 dhcp snooping trust
Default Configuration
By default, interfaces are untrusted.
Command Modes
Interface Configuration mode (physical and port-channel)
User Guidelines
Configuring an interface as trusted disables DHCP snooping address
validation checking and exposes the port to IPv6 DHCP DoS attacks.
DHCP snooping must be enabled globally and on the VLAN for which the
port is a member for this command to have an effect. Configuring a port as
trusted indicates that the port is connected to an IPv6 DHCP server or to a
trusted device. Configuring a port as untrusted indicates that the switch
should firewall IPv6 DHCP messages and act as if the port is connected to an
untrusted device.
Use the
ipv6 verify source command to disable traffic from untrusted sources
on an interface.
ipv6 dhcp snooping verify mac-address
Use the ipv6 dhcp snooping verify mac-address command to enable the
additional verification of the source MAC address with the client hardware
address in the received DHCP message.
Syntax
ipv6 dhcp snooping verify mac-address