Dell N1100-ON, Справочное руководство

Страница: 2150 / 2332

Switch Management Commands
2150
User Guidelines
This command is not supported on Dell EMC N1100-ON switches. Dell
EMC N1100-ON switches support configuration of a single IP address in
interface vlan configuration mode. That IP address is used as the source
interface address for this function..
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#interface vlan 1
console(config-if-vlan1)#ip address dhcp
console(config-if-vlan1)#exit
console(config)#logging source-interface vlan 1
logging traps
Use the logging traps command in Global Configuration mode to set the
lowest severity level at which SNMP traps are logged. To revert the urgent
severity level to its default value, use the no form of this command.
Syntax
logging traps severity
no logging traps
• severity—If you specify a severity level, log messages at or above the
severity level are e-mailed. The severity level may either be specified by
keyword or as an integer from 0 to 7. The accepted keywords, and the
numeric severity level each represents, are as follows.
–
emergency (0)
– alert (1)
– critical (2)
– error (3)
– warning (4)
– notice (5)