Dell N1100-ON, Справочное руководство

Страница: 2027 / 2332

Switch Management Commands
2027
User Guidelines
Debug commands should be used with caution. Switch behavior may be
adversely affected by the additional processing load incurred by enabling
debug output.
Example
console#debug aaa accounting
debug arp
Use the debug arp command to enable tracing of ARP packets. Use the no
form of this command to disable tracing of ARP packets.
Use of the optional
vrf parameter executes the command within the context
of the VRF specific routing table.
Syntax
debug arp [ vrf vrf-name]
no debug arp
• vrf-name—The name of the VRF associated with the routing table
context used by the command. If no vrf is specified, the global routing
table context is used.
Default Configuration
ARP packet tracing is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
Only IPv4 addresses are supported with the vrf parameter.
This vrf parameter is only available on the N3000/N3100/N4000 switches.