Dell N1100-ON, Справочное руководство

Страница: 1748 / 2332

Layer 3 Routing Commands
1748
redistribute (OSPFv3)
Use the redistribute command in Router OSPFv3 Configuration mode to
configure the OSPFv3 protocol to allow redistribution of routes from the
specified sources.
Syntax
redistribute protocol [ metric metric-value] [ tag tag-value] [ route-map route-
tag]
no redistribute protocol
• protocol —One of the following:
– static—Specifies that static routes are to be redistributed.
– connected—Specifies that connected routes are to be redistributed.
– bgp—Specifies BGP originated routes are to be redistributed.
– rip—Specifies RIP originated routes are to be redistributed.
• metric-value — Metric value used for default routes. (Range: 0-16777214)
• tag-value— Insert the specified tag value into redistributed routes.
• route-tag—Filter redistributed routes using the specified route map.
Default Configuration
The default tag value is 0.
There is no default metric or route map configured.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
When redistributing a route metric, the receiving protocol must understand
the metric. The OSPF metric is a cost value equal to 10
8
/ link bandwidth in
bits/sec. For example, the OSPF cost of GigabitEthernet is 1 = 10
8
/10
8
= 1.
The RIP metric is a hop count with a maximum value of 15. Redistribution of
BGP-originated routes is only available on BGP-enabled routers.