Dell N1100-ON, Справочное руководство

Страница: 1600 / 2332

Layer 3 Routing Commands
1600
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command does not clear static multicast route entries.
When a * entry is deleted through this command, it cannot be formed again
until it is expired in MLD and started again via the host. The default mcache
time-out is 210 seconds.
Example
The following example deletes all entries from the IPv6 multicast routing
table:
console# clear ipv6 mroute *
The following example deletes from the IPv6 multicast routing table all
entries that match the given multicast group address (FF4E::1), irrespective
of which source is sending for this group:
console# clear ipv6 mroute FF4E::1
The following example deletes from the IPv6 multicast routing table all
entries that match the given multicast group address (FF4E::1) and the
multicast source address (2001::2):
console# clear ipv6 mroute FF4E::1 2001::2
ipv6 pim (VLAN Interface config)
Use the ipv6 pim command in VLAN Interface configuration mode to
administratively enable PIM multicast routing mode on a particular IPv6
router interface. Use the
no
form of this command to disable PIM on an
interface.
Syntax
ipv6 pim