Dell N1100-ON, Справочное руководство

Страница: 1411 / 2332

Layer 3 Routing Commands
1411
Command Mode
Route Map Configuration
User Guidelines
The set community command can be used to assign communities to routes
originated through BGP’s network and redistribute commands and to set
communities on routes received from a specific neighbor or advertised to a
specific neighbor. It can also be used to remove all communities from a route.
To remove a subset of the communities on a route, use the set comm-list
delete command.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(route-map)#set community no-advertise
set ipv6 next-hop (BGP)
To set the IPv6 next hop of a route, use the set ipv6 next-hop command in
route-map configuration mode. To remove a set command from a route map,
use the no form of this command.
Syntax
set ipv6 next-hop ipv6-address
no set ipv6 next-hop
• ipv6-address — The IPv6 address set as the Network Address of Next Hop
field in the MP_NLRI attribute of an UPDATE message. This argument
must be in the form documented in RFC 2373, where the address is
specified in hexadecimal using 16-bit values between colons.
Default Configuration
No next-hops are set by default.
Command Mode
Route Map Configuration