Dell N1100-ON, Справочное руководство

Страница: 1267 / 2332

Layer 3 Routing Commands
1267
console(config-router)# neighbor 2001::2 remote-as 65003
console(config-router)# neighbor 2001::2 allowas-in 3
neighbor connect-retry-interval
Use this command in to configure the initial connection retry time for a
specific neighbor.
Syntax
neighbor { ip-address | ipv6-address [ interface interface-id ] | autodetect
interface interface-id} connect-retry-interval retry-time
no neighbor { ip-address | ipv6-address [ interface interface-id ] | autodetect
interface interface-id} connect-retry-interval
• ip-address—The neighbor’s IPv4 address.
• ipv6-address—The neighbor’s IPv6 address. If the neighbor’s IPv6 address
is a link local address, the local interface must also be specified. The
interface must be a VLAN routed interface.
• interface interface-id—A routing interface identifier (VLAN identifier).
• autodetect interface interface-id—The routing interface on which the
neighbor’s link local IPv6 address is auto detected. The interface must be a
VLAN routed interface.
• retry-time—The number of seconds to wait before attempting to establish
a TCP connection with a neighbor after a previous attempt failed.
Default Configuration
The default value is 2 seconds.
Command Mode
BGP Router Configuration mode
IPv4 Address Family Configuration mode
User Guidelines
If a neighbor does not respond to an initial TCP connection attempt, the
N3000/N3100/N4000 Series switch retries three times. The first retry is after
the retry interval configured with neighbor connect-retry-interval . Each