Dell Latitude 7410, Руководство по обслуживанию

Страница: 51 / 81

Steps
1. Align and place the system board into the palmrest assembly, and replace the three (M2x2.5) screw securing the system board to the
palmrest assembly.
2. Place the USB Type-C bracket on to the USB C ports.
3. Secure the USB Type-C bracket using the three (M2x5) screws.
4. Connect the following cables:
• Battery LED cable
• Touchpad cable
5. Connect the speaker cable to the connector on the system board.
6. Connect the eDP and camera cable to the connectors on the system board.
7. Place the eDP bracket on the display cable and install the two (M2x2) screws securing it to the system board
8. Re-route the antennae cable on the system board and reconnect the WWAN antennas.
9. Place the WWAN bracket on the antennas and install the single (M2x2.5) screws securing it to the system board.
Next steps
If you are replacing a component, remove the existing component before performing the installation procedure.
1. Install the:
a. Heatsink assembly
b. WLAN antennae
c. Solid state drive
d. Battery
e. Base cover
2. Follow the procedure in After working inside your computer .
Keyboard
Removing the keyboard
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the:
a. Base cover
b. Battery
c. WLAN antennas
d. Heatsink assembly
e. System board
NOTE: System board can be disassembled without having to remove the heatsink assembly.
f. Solid state drive
About this task
The following images indicate the location of the keyboard and provide a visual representation of the removal procedure.
Disassembly and reassembly 51