Installing 4-cell battery
Steps
1. Insert the battery into the slot on the computer.
2. Route the battery cable through the routing clip and connect the battery cable to the connector on the system board.
NOTE:
Route the battery cable, if the cable at the base of the battery is un routed.
3. Replace the M2 x 5 screws (2) to secure the battery to the computer.
4. Install the
After working inside your computer
.
PCIe Solid State Drive (SSD)
Removing PCIe SSD
Steps
Before working inside your computer
.
2. Remove the
.
3. Disconnect the battery cable from the connector on the system board.
4. To remove the PCIe SSD:
a. Loosen the M2 x3 captive screw that secures the SSD bracket [1].
b. Remove the SSD bracket [2].
c. Remove the PCIe SSD from the connector on the system board [3].
Removing and installing components
17
