c
d
3
To remove the LED board:
a Disconnect the LED board cable from the LED board [1].
b Remove the tape that secures the LED board to the touchpad panel [2].
c Remove the 2 (M2 x 3) screws that secure the LED board on the computer [3].
d Lift the LED board from the computer [4].
Installing the LED board
1
Install the LED board into the slot.
2
Replace the 2 (M2 x 3) screws to secure the LED board.
3
Affix the tape to secure the LED board.
4
Connect the LED board cable to the LED board.
5
Install the:
a
b
c
d
NOTE:
To install both cards if equipped.
6
Follow the procedure in
After working inside your computer
.
Heat Sink
22
Removing and installing components
